There are a lot of nifty modifications that can be made to this gun to improve performance, change the look, feel, or even caliber (with a. The Kel- Tec P-11 is compact and lightweight, thanks to its locked breech. Ten round and optional twelve round magazines available. Though tiny, it feels like you're holding a much larger handgun because of the exceptional ergonomic design. Kel-Tec P-11 9mm 3.1' 10 Rd - 296.99 The P-11 is a semi-automatic, locked-breech, DAO, pistol, chambered for the 9mm Luger cartridge. I particularly like the feel of this gun. Still, it'll put a 3-inch grouping from a bench rest at 15 yards, which is excellent for any small pistol. It weighs under a pound, and thus felt recoil will increase. Of course, given its small size, there are certain trade-offs that one must make. Because of its small size, however, the P-11 can just as easily be carried as a backup or a deep concealment weapon. Similar in size to a Walther PPK, the P-11 shoots a 9mm Luger round, considered by many to be the minimum for a primary weapon. Few protrusions on the pistol could catch on a pocket holster, a deep concealment, or inside of waistband holster.The Kel-Tec P-11 is a relative newcomer to the world of small, easily concealed pistols. All edges were rounded and smoothed allowing comfort while carrying concealed. The gun easily fit into a pocket, small holster, or inside a handbag. The barrel was near the minimum length possible with a Browning tilting-barrel system of operation. It was marketed to users who wanted a concealable firearm with a "full-power" defensive cartridge. It was only slightly wider than the staggered-column magazine it used. The P-11 was designed for concealed carry by members of the general public and law enforcement officers. The resulting PF-9 pistol weighs about the same loaded as the P-11 empty and is somewhat slimmer. In 2006, Kel-Tec introduced a single-stack pistol based on the P-11 with engineering improvements borrowed from the P-3AT. Kel-Tec has suspended production of these pistols and conversion kits. These models mated a P-11's frame to a larger slide width and barrel. These weapons were designated P-40 and P-357. ( December 2012) ( Learn how and when to remove this template message)įor a short period, the P-11 was offered in. Unsourced material may be challenged and removed. Please help improve this article by adding citations to reliable sources. This section needs additional citations for verification. Accessories such as trigger shoes, finger-rests, belt clips, steel guide rods to replace the factory installed polymer guide rod, gray- and OD green-colored polymer grip housings, night sights, and other accessories are also available from the manufacturer.
#Kel tec p 11 dealer nh series#
Smith & Wesson series 69 compact 12-round magazines would also work, with a matching short adapter sleeve, as well. An adapter was available that would wrap around the base of 15-round Smith & Wesson model 59-style magazines. Then to continue your Gold Dealer membership and enjoy all its benefits, simply purchase 10,000 (excluding Gun Genie Sales) during the 12 months. The P-11 would also accept some Smith & Wesson 59 series magazines. To become a Gold Dealer simply purchase ten (10) non-allocated guns on one (1) order or purchase 10,000 of merchandise (excluding Gun Genie Sales) from Davidson’s in a twelve (12) month period. A firing pin spring and low-mass hammer prevented discharge if the gun was dropped.
#Kel tec p 11 dealer nh manual#
The P-11 lacked an external manual safety, relying instead on a long and heavy double action only trigger pull, which requires 9 pounds of pressure, to prevent accidental discharge. At 17.1 oz (480 g) unloaded, the handgun itself was comparatively light. The slide, barrel, and magazine were steel. The P-11 used an aluminum receiver inside a polymer grip housing held on with polymer pins. The P-11 was designed by Swedish-born George Kellgren, the designer of many earlier Husqvarna (Sweden), Intratec, and Grendel brand firearms.